I'm trying to spin up a POC of vRA 7. I deployed the appliance, setup the Windows IaaS host according to the documented requirements. I am doing a minimal install, went through the Installation Wizard with no issues all the way to the 'Validation' step. Once here, I click on Validate, and the "Validation is in progress" message appears. However, nothing else happens. It stays at 0%, there is virtually no CPU or network activity on either the appliance or the IaaS host. I let it sit for over 10 hours, nothing. I tried rebooting the appliance and host, got back to the Validation step (progress was saved, thankfully,) but still have the same problem. I never get a timeout or any error messages, it just sits there and does nothing. I can click the 'Previous" button, navigate back and forth through the wizard as normal, even change values or re-generate certificates, etc. I just can't get past (or even into) Validation.. Anyone else seen this, or have any suggestions? I'm think I might just re-deploy the appliance, but I'm not feeling confident that will make any difference at this point.
↧